User Guide for XHP90 Flashlight (Wholefire)
WholeFire XHP90 Rechargeable Led Flashlight Instructions
Warning:
The LED flashlight is a high-intensity lighting device capable of causing eye damage. Avoid shining the light directly into the eyes.
Do not use over voltage, the voltage should not excees 4.2V, please do not reverse the battery, otherwise it will burn the circuit board.
26650 3.7v Rechargeable Battery Specifications:
Battery Type: 26650 Rechargeable Li-ion Battery
Size: 26*65mm
Voltage: 3.7v
Material: Li-ion Battery
Rechargeable times: Up to 1800 times
No memory effect
Environmentally friendly
XHP90 LED Flashlight Specifications:
Beads: XHP90 LED Beads
5 -Modes: High - Middle-Low- Strobe-SOS
Adjustable Focus: Yes
Flashlight Color: Black
Emitted Color: White Light
Case material: Durable aircraft-grade aluminum
Charging mode: USB Charging
Dimensions: 243mm*60mm*35mm(9.56"x2.36"x1.38")
LED Life: More than 100,000 hours
Chips : XHP90 , 6 times brighter than L2 .
Battery: 2 x 186-50 or 2 x 266-50 Batteries
How to charge 26650 battery? there are two ways:
1-26650 battery charge in flashlight:
Pls put battery positive direction towards to flashlight head;
pls use quick charger adapter or mobile phone adapter to connect usb cable to insert on wall charger, that will be charge faster,dont connect usb with Electronic products, like computer laptop, because it charge slower or can not charge battery to full.
After you plugged in to charge, the indicator light is flashing blue/or only 1-3 solid blue light when you charging it, and then will turn to 4 solid blue light after full charge. It normally needs 4-6 hours to fully charge.
2-Could charged 26650 battery by battery charger:
U could put it on your own battery charger which could charge 26650 battery, pls follow your battery charger step to charge.
Battery Replacement:
Unscrew the light head to insert the battery with anode(＋) toward the light head, screw the light to test. Please DON’T INSERT the battery incorrect way, otherwise it will short circuit and CAUSE A FIRE!
Battery WARNING:
DO NOT dispose in fire or heat;
DO NOT puncture,damage,and disassemble;
DO NOT mix fresh batteries with used batteries
Usage and Maintenance
- Please do not disassemble the sealed head, doing so can cause damage to the flashlight and will void the warranty.
- If Batteries are attached to the flashlight when received, please remove the insulation sheet in the flashlight before using.
- High-power lights like the xhp series flashlights should use a battery with high current discharge capability; we suggest using a high-quality battery to increase the run time of this high-intensity light.
- Please take out the battery if the flashlight will not be used for a long time, or it may cause damage from electrolyte leakage or battery explosion.
- Please clean the contacts of your light from time to time, especially if the light flickers or does not light up. Do not use a high-volt adapter to charge the flashlight or battery directly, the suitable volt is under 5V.
There may be several reasons for a flickering or not working light:
Reason A: The battery needs replacing.
Solution: Replace the battery (Please confirm the correct installation of anode and cathode, model type)
Reason B: The threads PCB board contact or other contacts are dirty.
Solution: Clean the contact points with an alcohol-soaked cotton swab.
If the above methods don't work, please contact the distributors and refer to the warranty policy.